Flow Pro Servo Mount - For FMS FCX24

This mount will fit your FMS FCX24 front axle and will allow the use of longer stronger servos and has multiple positions to finally tune your FCX24. Can do 4 link or 3 Link.  You can adjust Anti-dive or Anti squat (for 4 Wheel Steer) in either direction. There is one lower position and 3 upper positions. Bolts on the front and back of the front axle housing.   Weighs 4.5 grams

Going for the pure performance gain and have realstate? Go with the Battery On Axle (BOA) Mount to take the battery sprung wieght to unsprung weight by placing it on the axle. More traction! Hardware and veclro straps included as well as new drag link. Weighs 5.5 grams with straps

 A high Anti-Dive value will help keep your front end down on steep climbs transferring power to the tires and not the chassis but also lifts the rear end slightly under hard acceleration which forces the front end down.

 A low anti-dive value under 100% will cause the front suspension to compress under braking called nose-dive. Under acceleration a low anti dive geometry will cause the front end to lift and the suspension to unload which also shifts weight to the rear of the truck. This good for faster trucks on dirt, helps rock bouncers keep the suspension extended during a climb and for mud drag racing. Your chassis and link setup will determine your final values. Good measure to find your values on your tuck and even better to just test each configuration out

 Anti-Dive above 100% is good for hardcore technical rock crawling

 Anti-Dive below 100 % is good short course racing, rock bouncers, mud trucks